Eaton PC917-2000 Guide de l'utilisateur télécharger pdf (Page 30)

Monitored ePDU Web Interface

Eaton

User's Guide for Basic, Monitored, and Switched ePDUt S 164202115 Rev 1

Network Settings

Unit IP Address: This value should be entered in standard dot notation (e.g.,

192.168.168.168)

Net mask: This value should be entered in standard dot notation (e.g.,

255.255.255.0) It requires a soft reboot to take effect.

Gateway: This value should be entered in standard dot notation (e.g., 192.168.168.1)

It requires a soft reboot to take effect.

Mac Address: This value is unique to each unit and cannot be changed.

Alarm Trap Destination IP: This value should be entered in standard dot notation

(e.g., 192.168.168.100)

Mail Server IP: This value should be entered in standard dot notation (e.g.,

192.168.168.1). All email will be sent via the server using the SNMP protocol.

Alarm E-Mail Address: Up to 31 characters may be used to specify an email

address for all logs

NOTE Both the Mail Server IP and Email address are required for email messages to be sent.

Figure 8. ePDU Configuration continued (Typical)

Current Alarm Settings

Each current measurement can be configured to have both lower and upper current

thresholds. Each values corresponds to the sum of currents measured in the 6-outlet

set. The current threshold is measured in Amps. The range for the threshold value is

from 0 to 100.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 115 116

Pas de commentaire

Eaton PC917-2000 Guide de l'utilisateur Page 30