Eaton PC917-2000 Guide de l'utilisateur télécharger pdf (Page 107)

Switched ePDU Advanced Features

Eaton

User's Guide for Basic, Monitored, and Switched ePDUt S 164202115 Rev 1

Table 30. Settings Description

Parameter Type Description

Network Interface

Parameters

These parameters include whether DHCP is enabled, as well as the static

IP address, subnet mask, and default gateway values. These parameters are

also available from the Network Settings menu.

Security Parameters The root password is the same as the Admin password. Changing the root

password here also changes the Admin password.

Hardware Parameters The serial port baud rate can be changed to 9600, 19200, or 38400.

The MAC address must be a unique number on your network; if the MAC

address needs to be changed, it can be modified here.

By default the CPU delays for 5 seconds to allow the user a chance to press

any key to enter this boot setup; this delay time can be lengthened or

shortened.

Normally the Ethernet port auto-negotiates with the hub or switch, but the

duplex setting is used if auto-negotiation fails.

Reset System Defaults Resetting to defaults restores all settings (except the DHCP, IP address,

subnet mask, and default gateway settings) to factory defaults.

Select the Number of

Outlets

Select the number of outlets that are present on your Switched ePDU.

Strapping ID This setting is the most important part of configuring strapping. Each

Switched ePDU connected together on a strapping bus must have a unique

strapping ID. The Switched ePDU with a strapping ID of 0 is the primary (or

master) Switched ePDU, and those with strapping IDs of 1 to 23 are

secondary (or slave) Switched ePDUs.

Reboot to FTP Server Select Y only when loading new firmware. The Switched ePDU reboots into

the FTP loader application

after making this selection.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 115 116

Pas de commentaire

Eaton PC917-2000 Guide de l'utilisateur Page 107