Eaton 5115 Manuel d'utilisateur télécharger pdf (Page 7)

500 - 1400 VA

User’s manual

1015715

Revision B

2. Installation

Inspecting the Equipment

If any equipment has been damaged during shipment, keep the shipping cartons and

packing materials for the carrier or place of purchase and file a claim for shipping

damage. If you discover damage after acceptance, file a claim for concealed damage.

To file a claim for shipping damage or concealed damage: 1) File with the carrier

within 15 days of receipt of the equipment; 2) Send a copy of the damage claim within

15 days to your service representative.

Safety Precautions

Read the following precautions before you install the UPS.

SAVE THESE INSTRUCTIONS. This manual contains important instructions that you

should follow during installation and maintenance of the UPS and batteries.

Please read all instructions before operating the equipment and save this manual for

future reference.

WARNING

This UPS contains its own energy source (batteries). The output receptacles

may carry live voltage even when the UPS is not connected to an AC supply.

Do not remove or unplug the input cord when the UPS is turned on. This

removes the safety ground from the UPS and the equipment connected to

the UPS.

To reduce the risk of fire or electric shock, install this UPS in a temperature

and humidity controlled, indoor environment, free of conductive

contaminants. Ambient temperature must not exceed 40°C (104°F). Do not

operate near water or excessive humidity (95% max).

To comply with international standards, the sum of earth leakage current

from the load connected to the UPS must not exceed 1.5 mA.

Installing the UPS

The following steps explain how to install the UPS. See “UPS Rear Panels” on page 9 for

the rear panel of each model.

Please see a typical installation (fig 2)

1. If you are installing power management software, connect your computer to the

USB port or UPS communication port using the supplied cable(see page12 and 13).

NOTE

If you need to change the factory–set defaults for the output voltage or input

voltage range, see “Voltage Configuration” on page 11 before installing the UPS.

2. Unplug the power cord from your largest load. Plug this power cord into the male

inlet of your UPS. You do not need to remove the cord from the wall outlet.

1 2 3 4 5 6 7 8 9 10 11 12 ... 19 20

Pas de commentaire

Eaton 5115 Manuel d'utilisateur Page 7